Evolution 80GX Spezifikationen PDF herunterladen (Seite 9)

9Hangar 9 Sukhoi SU-26MM SE

Note: Use the 4-pin balance connection (THP4P10E) on

the receiver Li-Po batteries to make it easier to connect the

charger. The receiver extension can be used on the charger

balance lead for this purpose.

 7. Wrap a piece of foam rubber around the receiver

battery. Use a hook and loop strap to secure the

receiver battery to the side mount plate. Note the

direction of the leads: they will face to the rear of

the fuselage. Prepare a right and left battery for

installation at this time.

 8. Attach the side mount plate in the fuselage using

5-minute epoxy. The tabs on the plate will key into

the fuselage sides as shown. Install both the left and

right plates at this time. Insert the extension into the

jack on the side of the fuselage installed below the

switch so the voltage of the battery can be checked

without the need to remove the canopy hatch.

 9. Connect the switch for the regulator to the 6-inch

(152mm) extension from the regulator. Connect a

12-inch (305mm) EC3 extension to the power lead

from the regulator and to the receiver battery. Route

the lead through the openings in the formers. Use tie

wraps to secure the leads inside the fuselage so they

don’t move during flight. Make sure the lead for the

receiver is routed away from the power leads to avoid

radio interference.

Notice: When storing your model, make sure to unplug

the batteries from the regulators as the regulators draw a

small amount of power even when in the off position. If left

connected, they will drain the battery and leave it unusable.

 10. Repeat steps 6 through 9 to install the second

receiver battery and regulator in the fuselage. Make

sure to route and secure the power leads in the

fuselage so they are away from the servo and receiver

leads.

Battery and Regulator Installation -

Precision Aerobatics

Required Parts

Fuselage Hook and loop strap (2)

12-inch EC3 extension (2) Tie-wraps

Battery (2) Side mount plates (2)

1/4-inch (6mm) Foam rubber (not included)

Battery Mount Plate (2)

Regulators with accessories (2)

#4 x 1/2-inch sheet metal screws (8) (not included)

#4 washers (8) (not included)

6-inch (152mm) servo extension (2)

Required Tools and Adhesives

5-minute epoxy Scissors

Mixing cups Mixing sticks

Paper towels Thin CA

Hobby knife with #11 blade

We have tested two different locations for the receiver

battery and regulator positions inside the fuselage. The

following covers the installation of these components that

are best suited for a forward CG for precision aerobatics.

 1. Use a hobby knife with a #11 blade to remove

the covering on the fuselage for the two regulator

switches on the right and left sides of the fuselage.

Mount the switches using the hardware provided with

the switches.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Evolution 80GX Spezifikationen Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Evolution 80GX