Evolution 80GX Spezifikationen PDF herunterladen (Seite 19)

19Hangar 9 Sukhoi SU-26MM SE

 6. Attach the servo horn to the throttle servo. With the

throttle servo and carburetor linkage in the closed

position, use a felt-tipped pen to mark the linkage

where it crosses the hole on the servo arm that is

3/8-inch (9.5mm) from the center of the servo horn.

 7. Bend the pushrod wire 90-degrees at the mark made

in the previous step. Use a pin drill and 3/32-inch

(2.5mm) drill bit to enlarge the outer hole of the

servo arm.

 8. Secure the pushrod wire to the servo arm using a

pushrod connector. Snap the connector on the

pushrod wire to secure.

Installing the MTW 110 Canister and Header

(Available from Desert Aircraft)

Note: Before installing the canister muffler, you will want

to install the landing gear as described in the section

“Installing the Landing Gear” on Page 22.

 A. Use a felt-tipped pen to draw lines vertically that

connect the bottom of the fuselage to the sides of the

opening.

 B. Use a rotary tool and cut-off wheel to cut the former

along the lines made in the previous step.

 C. Carefully remove the section from the fuselage.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 19