Evolution 80GX Spezifikationen PDF herunterladen (Seite 11)

11Hangar 9 Sukhoi SU-26MM SE

 8. Connect the regulator to the receiver using a

12-inch (305mm) EC3 extension. Route the lead

through the openings in the formers. Use tie wraps to

secure the lead inside the fuselage so it doesn’t move

during flight. Make sure the lead for the receiver is

routed away from the power leads to avoid radio

interference.

Important: Keep the power leads to the receiver remote

antenna leads separated to avoid interference.

 9. Connect a 6-inch (152mm) servo extension to the

lead on the battery. Wrap the battery using foam

rubber. Use a hook and loop strap to secure the

receiver battery to the battery mount plate.

 10. Use 5-minute epoxy to secure the battery mount

plate in the fuselage next to the fuel tank and behind

the servo as shown. Once the epoxy cures, connect

the lead from the battery to the regulator. Use tie

wraps to secure the leads so they don’t move in the

fuselage during flight.

 11. Repeat Steps 7 through 10 to install the remaining

battery and regulator on the opposite side of the

fuselage.

Notice: When storing your model, make sure to unplug

the batteries from the regulators as the regulators draw a

small amount of power even when in the off position. If left

connected, they will drain the battery and leave it unusable.

Engine Installation (Evolution 80GX)

Required Parts

Fuselage assembly 90-degree snap link (2)

1/4-inch lock washer (4) 1/4-20 blind nut (4)

Pushrod support (2) Balsa triangle stock (2)

Engine Muffler

Spinner Propeller

Ignition switch Ignition battery

#4 washer (3) Hook and loop strap

Tie wraps Fuel line

5mm aluminum engine standoffs

Choke pushrod wire, 14

-inch (362mm)

4-40 x 1/2 socket head bolt (3)

2mm x 4-40 ball end with hardware (2)

Throttle pushrod wire, 15

-inch (394mm) (2)

1/4-20 x 3/4-inch socket head bolt (4)

Manual choke wire support (2)

(one extra included with kit)

Nylon pushrod housing 12-inch (305mm) (2)

(if using a choke servo)

Required Tools and Adhesives

Threadlock Drill

Pin vise Felt-tipped pen

Hobby knife Pliers

Rotary tool Sanding drum

Cut-off wheel Razor saw

Medium sandpaper Side cutters

Silicone adhesive Ruler

Hobby scissors Canopy glue

Rotary tool with sanding drum

Hex wrench: 1.5mm, 3/32-inch, 5/64-inch, 3/16-inch

Phillips screwdriver: #1 Medium CA

Drill bit: 3/32-inch (2.5mm), 5/16-inch (8mm)

The laser etched markings on the firewall are used for

the installation of the Evolution 80GX. If you are using a

different engine, you will need to use the template included

with your engine for locating any mounting holes and

openings.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Evolution 80GX Spezifikationen Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Evolution 80GX