Evolution 80GX Spezifikationen PDF herunterladen (Seite 10)

10 Hangar 9 Sukhoi SU-26MM SE

 2. Use a hobby knife with a #11 blade to remove the

covering on the fuselage for the charge jacks on the

right and left sides of the fuselage. Install charge

jacks in the larger cutouts below the switches.

 3. Locate the side mount plates. The tabs on one

side are longer than those on the opposite side. The

longer tabs will face down into the fuselage when the

plates are installed.

 4. Apply 2–3 drops of thin CA in each of the mounting

holes to harden the surrounding wood. This will keep

the screws from backing out in flight.

 5. Attach the regulator to the side mount plate using

four #4 x 1/2-inch sheet metal screws (not included)

and four #4 washers (not included).

 6. Repeat Steps 1 through 5 to prepare the second

regulator for installation. Make sure to construct a

regulator for the right and left side of the fuselage.

 7. Connect the switch lead to the regulator. Attach

the side mount plate in the fuselage using 5-minute

epoxy. Note that the lead on the regulator for the

battery input will face to the front of the fuselage.

The tabs on the plate will key into the fuselage sides

as shown. Install both the left and right plates at this

time.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 10