Evolution 80GX Spezifikationen PDF herunterladen (Seite 22)

22 Hangar 9 Sukhoi SU-26MM SE

 3. Use the screws removed from the fuselage in Step

2 to secure the stabilizer to the fuselage.

Note: A small of canopy glue on the threads of the

stabilizer mounting screws will allow for easy removal, but

help prevent the screws from vibrating loose in flight.

 4. Repeat Steps 2 through 3 for the remaining stabilizer.

Landing Gear Installation

Required Parts

Fuselage assembly Landing gear assembly

Wheel pant (right and left) 6-32 lock nut (4)

#8 washer (4) #4 washer (4)

Wheel and axle assembly (2)

4-40 x 1/2-inch socket head screw (4)

8-32 x 3/4-inch socket head screw (4)

Required Tools and Adhesives

Threadlock Light machine oil

Open end wrench: 10mm, 13mm

1/4-inch ratchet drive

11/32-inch socket, 1/4-inch drive

3-inch (76mm) drive extension, 1/4-inch drive

Hex wrench: 3/32-inch, 1/8-inch

 1. Use a 3/32-inch hex wrench to remove the 4-40 x

3/4-inch socket head screws securing the landing

gear cover from the fuselage.

 2. Remove the lock nut from the axle. Insert the axle

in the large hole of the landing gear. Use a 10mm

and 13mm open end wrench to tighten the lock nut,

securing the axle to the landing gear. Install both

wheels at this time.

 2. Attach the landing gear to the fuselage using four

8-32 x 3/4-inch socket head screws, four #8 washers

and four 8-32 lock nuts. Use a 11/32-inch socket

wrench with extension and driver and 1/8-inch hex

wrench. Note the gear will angle forward slightly

when installed.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 22