Evolution 80GX Spezifikationen PDF herunterladen (Seite 16)

16 Hangar 9 Sukhoi SU-26MM SE

 24. Mount the propeller and spinner on the engine. Make

sure to balance the propeller to reduce any vibrations

that may be transmitted to the airframe.

Optional Tuned Pipe Installation

Required Parts

Fuselage assembly Tuned pipe

Tuned pipe header Tuned pipe coupler

Medium silicone tubing #4 washer (2)

4-40 x 1/2-inch socket head screw (2)

Tuned pipe mount, full, small inner diameter (2)

Tuned pipe mount, full, large inner diameter (2)

Tuned pipe mount, half

Required Tools and Adhesives

Covering iron Trim seal tool

Hex wrench: 3/32-inch 30-minute epoxy

Mixing stick Mixing cup

Paper towel Rubbing alcohol

Hobby knife with #11 blade

Note: We have designed the Sukhoi SU-26MM fuselage

to allow for two sections of the fuselage to be removed

for cooling. Our flying model only has the front section

removed. Prepare the fuselage based on the need for your

particular tuned pipe and particular flying situation.

 1. Use a hobby knife with a #11 blade to remove the

covering from the bottom of the fuselage to allow

cooling air to pass through for the tuned pipe. Use a

covering iron and trim seal tool to seal the covering

in place on the fuselage.

Note: The length of the opening in the bottom of the

fuselage will be determined by your particular pipe

selection. Check the pipe length before opening the bottom

of the fuselage.

 2. Pass the clear fuel tubing through the holes in the

full tuned pipe mounts. Check the fit of the mount

on your particular pipe, as there are different sizes

provided to allow the installation of a variety of tuned

pipes. Once the correct mount has been determined,

use 30-minute epoxy to secure the mount in the

fuselage as shown.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 16