Evolution 80GX Spezifikationen PDF herunterladen (Seite 20)

20 Hangar 9 Sukhoi SU-26MM SE

 D. Use a hobby knife to trim the covering 1/8-inch

(3mm) away from the edges of the opening. The

excess material will be sealed back into position to

fuel-proof the area and make a clean installation of

the opening.

 E. Use a covering iron to seal the edges of the covering

inside the fuselage.

 F. Remove the covering from the bottom of the fuselage

and cut the stringers as shown. Repeat Steps D

through F to seal the covering around the opening.

This is necessary to allow cooling air to pass through

the fuselage to cool the canister muffler.

 G. Remove the material from the cowling to clear the

exhaust system and to provide cooling air to pass

over the engine. Refer to the photos in the tuned pipe

section regarding mounting the cowling.

Rudder and Tail Wheel Installation

Required Parts

Fuselage assembly Rudder

Rudder hinge wire Tail wheel assembly

Tail wheel steering spring (2)

2.5mm x 18mm socket head sheet metal screw (2)

Required Tools and Adhesives

Thin CA Drill

Hex wrench: 3mm Ruler

Flat file Threadlock

Hex wrench: 2.5mm, 3/32 inch

 1. Use a flat file to sharpen one end of the rubber hinge

wire. This will help the wire guide itself through the

hinges. Line the hinges up between the rudder and

fuselage. Insert the rudder hinge wire using a drill.

The wire will insert slightly in the rudder balance

tab so there is clearance for the tail wheel bracket

installed later in this section of the manual. Once

installed, the wire will extend 3/8-inch (9.5mm) below

the bottom of the fuselage.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 20