Evolution 80GX Spezifikationen PDF herunterladen (Seite 12)

12 Hangar 9 Sukhoi SU-26MM SE

Important: The fuel vent line has been wrapped up and

back around the tank to stop the fuel tank from siphoning

fuel during flight.

 1. Use a drill and 5/16-inch drill bit to drill the four

mounting holes for the engine mounting bolts.

 2. Use a razor saw and rotary tool with a sanding drum

to remove the material from the firewall for the

carburetor.

 3. Lightly sand the outside of the 12-inch (305mm)

clear pushrod tube. Insert the tube through the hole

in the sub-firewall and direct it toward the throttle

servo. Position the tube so 2 inches (52mm) of the

tube extends forward of the sub-firewall. If you have

installed the choke servo, install the second tube at

this time as well.

Note: The pushrod tubes may need to be relocated slightly

depending on the style of carburetor on your engine. It is

best not to glue the pushrod tube at this time.

 4. Use side cutters to trim the throttle (and choke)

pushrod tubes at the front edge of the servos.

 5. Install the 1/4-20 blind nut in the backside of the

firewall. Use a 1/4-20 x 3/4-inch socket head bolt

and 1/4-inch washer to draw the prongs of the blind

nut into the firewall. Use a 3/16-inch hex wrench

to tighten the bolts, drawing the blind nuts into the

firewall. Install all four blind nuts at this time.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 12