Evolution 80GX Spezifikationen PDF herunterladen (Seite 21)

21Hangar 9 Sukhoi SU-26MM SE

Note: Always use threadlock on metal-to-metal fasteners.

 2. Attach the rudder servo arm onto the rudder servo

using a 2.5mm hex wrench. Once installed, tighten

the clamping bolts using a 3/32 hex wrench.

 3. Apply 2–3 drop of thin CA in each of the holes for the

tail wheel bracket mounting screws.

 4. Check the fit of the tail wheel assembly on the bottom

of the fuselage to make sure the rudder hinge wire

does not interfere or make contact with the top of

the tail wheel carbon leg during its installation. If the

rudder hinge wire does interfere, use a drill as shown

in step 1 to insert the wire slightly into the rudder

balance tab or use side cutters to trim the excess

wire. Attach the tail wheel assembly to the fuselage

using two 2.5mm x 18mm socket head sheet metal

screws. Use a 3mm hex wrench to tighten the

screws.

Note: The tail wheel assembly will keep the rudder hinge

wire from vibrating loose from the rudder hinges.

 5. Connect the steering arm from the rudder to the steering

arm on the tail wheel using two steering springs.

Stabilizer Installation

Required Parts

Fuselage assembly Stabilizer/elevator (2)

Stabilizer tube #4 nylon washer (4)

Required Tools and Adhesives

Threadlock Hobby knife

Hex wrench: 5/64-inch Canopy glue

 1. Slide the stabilizer tube into one of the stabilizer

halves.

 2. Remove the two 4-40 x 1/2 inch button head screw

and #4 nylon washers from the fuselage using a

5/64-inch hex wrench. Connect the lead from the

stabilizer to the lead in the fuselage. Secure the

extension using the supplied connector so it will not

unplug.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 21