Evolution 80GX Spezifikationen PDF herunterladen (Seite 14)

14 Hangar 9 Sukhoi SU-26MM SE

 12. Secure the pushrod wire to the servo arm using

a pushrod connector. Snap the connector on the

pushrod wire to secure. Lightly sand the pushrod

tube using medium sandpaper in the location of the

plywood pushrod support. This will allow the CA to

adhere the tube to the support.

Note: The servo arm may need to be trimmed to prevent it

from hitting the receiver battery if they are mounted on the

tray behind the servo for the precision aerobatic setup.

 13. Use medium CA to glue the plywood pushrod

support and the balsa triangle to the inside of the

fuselage. Glue the balsa support between the fuselage

side and pushrod support using medium CA. The

pushrod tube is then glued to the plywood pushrod

support using medium CA.

 14. Repeat Steps 9 through 13 to connect the choke

linkage to the choke servo. Note the servo and choke

will be in the open position when connecting the

linkage.

Note: If you attach the module to the engine box using

screws, make sure to use threadlock on the metal-to-metal

fasteners.

 15. Mount the ignition module to the side of the fuselage.

You can use a hook and loop strap or using a 3/32-

inch hex wrench, install three 4-40 x 1/2 socket head

bolts with three #4 washers.

 16. Make the connections between the engine and

ignition module following the instructions provided

by the engine manufacturer. Secure any leads using

tie-wraps to prevent them from interfering with the

operation of the engine.

 17. (Optional Ignition Light) Use a hobby knife and

#11 blade to remove the covering in the side of the

fuselage for the ignition light. Route the lead and LED

through the fuselage and insert the LED in the hole.

Use a small amount of silicone adhesive to glue the

LED in the fuselage.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 14