Evolution 80GX Spezifikationen PDF herunterladen (Seite 8)

8 Hangar 9 Sukhoi SU-26MM SE

Battery and Regulator Installation -

3D Flight

Required Parts

Fuselage Hook and loop strap (2)

12-inch EC3 extension (2) Tie-wraps

Battery (2) Side mount plates (2)

1/4-inch (6mm) foam rubber (not included)

Regulator with accessories (2)

#4 x 1/2 sheet metal screws (8) (not included)

6-inch (152mm) servo extension (2)

Required Tools and Adhesives

5-minute epoxy Scissors

Pin vise Drill bit: 5/64 inch (2mm)

Mixing cups Mixing sticks

Phillips screwdriver: #1 Paper towels

Hobby knife with #11 blade

We have tested two different locations for the receiver

battery and regulator positions inside the fuselage. The

following covers the installation of these components that

are best suited for an aft CG and 3D flight.

 1. Use a hobby knife with a #11 blade to remove

the covering on the fuselage for the two regulator

switches on the right and left sides of the fuselage.

Mount the switches using a #1 Phillips screwdriver

and the hardware provided with the switches.

 2. Use a hobby knife with a #11 blade to remove the

covering on the fuselage for the charge jacks on the

right and left sides of the fuselage. Install charge

jacks in the larger cutouts below the switches.

 3. Connect a 6-inch (152mm) servo extension to the

regulator for the connection to the regulator switch.

 4. Repeat steps 1 through 3 to install a second switch

and charge jack on the opposite side of the fuselage.

Prepare the second regulator for installation at this

time as well.

 5. Secure the regulators in the fuselage next to the

receiver. Use four #4 x 1/2-inch sheet metal screws

(not included) and four #4 washers (not included)

to secure each regulator. Make sure the regulators

are far enough back that they won’t interfere with

the installation of the canopy hatch. Plug the

regulators into the leads from the receiver, then

route the remaining lead and servo extension from

the regulators through the larger hole in the receiver

floor, keeping the remote receiver leads separated

from the power and servo wires.

 6. Locate the side mount plates. Note that the tabs on

one side are longer than those on the opposite side.

The longer tabs will face down into the fuselage when

the plates are installed.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Evolution 80GX Spezifikationen Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Evolution 80GX