Evolution 80GX Spezifikationen PDF herunterladen (Seite 23)

23Hangar 9 Sukhoi SU-26MM SE

 3. Use a 3/32-inch hex wrench and replace the 4-40 x

3/4-inch socket head screws securing the landing

gear cover on the fuselage.

Note: Always use threadlock on metal-to-metal fasteners.

Note: Before installing the wheel pants, we suggest adding

a small drop of light machine oil to the axles so the wheels

will roll smoothly during takeoff and landing.

 4. Use a 3/32-inch hex wrench to remove the two 4-40

x 1/2-inch socket head screws and two #4 washers

from the wheel pant. Attach the wheel pant to the

landing gear using the screws and a 3/32-inch hex

wrench to tighten the screws. Attach both wheel

pants at this time.

Wing Installation

Required Parts

Fuselage assembly Wing panel (right and left)

Canopy hatch #4 washer (4)

4-40 x 1/2 inch button head bolt (4)

Aluminum wing tube

Required Tools and Adhesives

Threadlock

Hex wrench: 5/64-inch

 1. Remove the preinstalled nylon wing bolts from the

wing at this time. Slide the wing tube into one of the

wing panels. The tube will slide in easily, so don’t

force it in farther than it will easily slide.

 2. Slide the wing tube into the socket in the fuselage

side. Slide the wing tightly against the side of the

fuselage.

Note: The 2-inch rear wing bolts supplied can be shortened

to make them easier to install. Do not trim the bolt any

shorter than 1-inch in length. Do not shorten the front

wing bolts from their original 2

-inch length.

 3. Connect the lead for the aileron. Use the two nylon

wing bolts to secure the wing to the fuselage. The

shorter 2-inch bolt will be installed near the trailing

edge, while the longer 2

-inch nylon bolt is installed

near the leading edge.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Keine Kommentare

Evolution 80GX Spezifikationen Seite 23