Evolution EVO42 Bedienerhandbuch PDF herunterladen (Seite 19)

EVO42

www.evolutionsteel.com

WARNING: Do not attempt to clean by inserting pointed

objects through openings in the machines casings etc. The

machines air vents should be cleaned using compressed dry air.

Excessive sparking may indicate the presence of dirt in the motor

or worn out carbon brushes.

If this is suspected have the machine serviced and the brushes

replaced by a qualiﬁed person.

Adjusting Gibs (Dovetail Slides) Free Play

Periodically check, lubricate and adjust as necessary. When

adjusting the gib strips the following procedure must be followed.

• Usingthesupplied3mmHexKeyloosenslightlythe3cap

screws. (Fig 12(A) shows 1 of the cap screws).With all 3 cap

screws loosened, ensure that the main slide is at the lowest

position.

• Usingthe2mmHexKeysuppliedturnthelowerandmiddle

adjusting screws to eliminate any free movement. (Fig 12 (B)

shows 1 of the adjusting screws).

• Movethemainslideupwardsuntilitstopedgeislevelwiththe

top of the dovetail slide way. Turn the upper adjusting screw to

take up any free movement.

• Operatethecrankhandletomovetheslideupanddown.There

should be no free play, yet no binding anywhere throughout the

range of travel.

• Ifnecessaryrepeattheaboveprocedureseveraltimesto

ensure that all free movement has been eliminated and that the

machine head moves up and down freely without any binding

and without any side to side movement.

• Re-tightenthe3capscrewswhenadjustmentiscomplete.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with

householdwaste.Pleaserecyclewherefacilitiesexist.Checkwith

your Local Authority or retailer for recycling advice.

Fig. 12 A

Fig. 12 B

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Evolution EVO42 Bedienerhandbuch Seite 19