Evolution RAGE3S3002 Bedienerhandbuch PDF herunterladen (Seite 22)

www.evolutionpowertools.com

PREPARING TO MAKE A CUT

DO NOT OVER-REACH

Keep good footing and balance. Stand to one side so

that your face and body are out of line of a possible

kickback.

Freehand cutting is a major cause of accidents and

MUST NOT BE ATTEMPTED.

• Ensure that the workpiece is always ﬁrmly resting

against the fence, and where practical is clamped

with the Hold Down Clamp to the table.

• The saw table should be clean and free from any

sawdust etc. before the workpiece is clamped into

position.

• Ensure that the ‘cut-off’ material is free to move

sideways away from the blade when the cut

is completed. Ensure that the ‘cut-off’ piece

cannot become ‘jammed’ in any other part of the

machine.

• Do not use this saw to cut small pieces. If the

workpiece being cut would cause your hand or

ﬁngers to be within 150mm of the sawblade, the

workpiece is too small.

Fig. 17

Fig. 18

Close up of Mitre pointer ﬁxing screw

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Keine Kommentare

Evolution RAGE3S3002 Bedienerhandbuch Seite 22